This article covers using the KICKR Direct Connect Adapter with a Windows 10 PC or laptop. Once the adapter is plugged into the KICKR (only supported on KICKR v5), simply plug an Ethernet cable into the adapter and the other end into your PC or router.


Wahooのアプリをダウンロード

Wahoo Fitnessアプリ

Wahoo Fitnessアプリを使用することで、トレーナーを最新の状態に維持し、ランニング、サイクリング、ワークアウト時にスマートフォンでデータを活用してトレーニング/フィットネス目標を達成できます。今すぐアプリを入手して、早速活用しましょう。

製品情報

デバイスの互換性

Requirements:

  • Direct Connect Adapter Firmware v. 1.0.0 or newer
  • KICKR v5 Firmware v. 4.1.1 or newer
  • Windows 10 version 19041 20H1 or newer
  • Bluetooth® enabled on your selected device

セットアップ

CONNECTING DIRECTLY TO A PC/LAPTOP

Direct Connect and Windows Firewall

If you're connecting the Direct Connect Adapter directly to your Windows PC, be sure to allow the connection when prompted (typically when opening your selected app). The current working connection type is automatically checked when the prompt appears, but can be edited, if needed, via Control Panel > Windows Defender Firewall > windowsbtle.exe

Once the connection is allowed, the trainer should appear when searching for trainers in your selected app similarly to how it would on a wireless connection.

Direct Connect and Mac

If you're connecting your trainer to a Mac, the process is as easy as plug and play: simply connect the adapter to your trainer, then connect the Ethernet cable to your Mac and start your desired app to find your trainer listed.

CONNECTING THROUGH A ROUTER OR OTHER NETWORK

Simply plug your direct connect adapter into your KICKR and connect the Ethernet cable to your router and it will be found on your PC within your selected app, similarly to how it would be found wirelessly.

注意:The KICKR Direct Connect Adapter is typically assigned an IP address automatically via DHCP. However, it's important to note that the adapter should be on the same subnet as the PC being used (example: if your PC has the address 192.168.0.100, the Direct Connect Adapter should be set to 192.168.0.xxx in order to be recognized on the PC). Most users should not have an issue with this, but there may be cases when running range extenders (or multiple routers) where the range extender is functioning in router mode instead of access point mode on a different subnet.

3rd Party Firewalls

3rd party firewalls may block traffic to the adapter including, Norton, McAfee, and Avast. Be sure to disable your 3rd party firewall or allow traffic on port 36866. Follow the instructions for your firewall to allow traffic on this port for the adapter to work properly.

OTHER IMPORTANT NOTES

Direct Connect and Bluetooth

Direct Connect requires Bluetooth® to function and uses the Bluetooth® protocol over TCP/IP. Your PC/MAC must have Bluetooth® drivers and must be enabled in the OS and App. Most computers in the past 7 years should have Bluetooth® by default, but a Bluetooth® adapter may be required if not.

Direct Connect and Multiperipheral

The Direct Connect Adapter is a 1:1 connection. It will only work in 1 app at a time. Always be sure to close any previously connected apps to ensure visibility with new apps. Note that the default Bluetooth® connection will remain available for other apps to use.

その他にご質問がある場合は、support.wahoofitness.comにアクセスして、追加のサポートをご利用ください。

Powered by Translations.com GlobalLink OneLink SoftwarePowered By OneLink